ZUMEX MINEX Manuel De L'utilisateur page 35

4
Remove the peel ejector from its holder, unscrew the wheels and dismantle the
extraction drums (Fig. 10).
5
Dismantle the peel container and jug (Fig. 11).
6
Dismantle the juice container and its filter, and then dismantle the drip tray
(Fig. 12).
7
Dismantle the dispenser with the anti-drip tap as shown in figure A. After
dismantling the tap, it can be washed by hand or in the dishwasher. It is not
advisable to put the tap and container unit into the dishwasher without
separating them, as the water will not reach the inside of the tap and clean it
properly.
From time to time, dismantle the tap as shown in B to ensure more exhaustive
cleaning. If the mobile part is stuck due to accumulated dry juice, proceed as
indicated in figures C and D.
• All the parts can be put in the dishwasher EXCEPT THE CONTAINER.
• To clean the extraction zone and the container, use a soft cloth dampened in water
and a detergent that is suitable for use washing dishes.
• Then rinse with running water to remove all traces of soap.
• After clearing the machine, reassemble all the elements in the reverse order
followed for dismantling them. Check that all the parts are properly assembled and
secured.
REMEMBER
Do not put the container in the dishwasher. To clean it use a soft cloth dampened
with water and a detergent that is suitable for washing dishes. Never use abrasive
products or lime-scale removers.
When replacing the peel ejector (Fig. 10), make sure it fits into its holder or pivots
correctly and that the ejector blade enters the male extractor drum groove as far as it
can go.