Publicité
Les langues disponibles
Les langues disponibles
APPLICATIONS
Tightening and loosening of all types of bolts and
nuts,
used
for
items.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
Insert
Pull out
Battery
Fig. 3
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
01Eng_WR18DSHL_US.p65
ASSEMBLY AND OPERATION
securing
structural
Handle
Push
Latch
11
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4, 5.
Battery
Pilot lamp
Charger
Fig. 4
Line
Fig. 5
11/15/12, 1:16 PM
English
11
Publicité
