Télécharger Imprimer la page

Sibir GSN 16010 Mode D'emploi page 33

Publicité

Les langues disponibles

Les langues disponibles

15
Helpful hints and tips
Energy saving tips
We recommend that you follow the
tips below to save energy.
Try to avoid keeping the door open
for long periods in order to conserve
energy.
Ensure the appliance is away from
any sources of heat (Direct sunlight,
electric oven or cooker etc)
Don't set the temperature colder
than necessary.
Don't store warm food or
evaporating liquid in the appliance.
Place the appliance in a well
ventilated, humidity free, room.
Please refer to Installing your new
appliance chapter.
If the diagram shows the correct
combination for the drawers, crisper
and shelves, do not adjust the
combination as this is designed to be
the most energy efficient
configuration.
Hints for freezing
When first starting-up or after a
period out of use, let the appliance
run at least 2 hours on the higher
settings before putting food in the
compartment.
Prepare food in small portions to
enable it to be rapidly and completely
frozen and to make it possible to
subsequently thaw only the quantity
required.
Wrap up the food in aluminum foil or
polyethylene food wraps which are
air tight.
Do not allow fresh, unfrozen food to
touch the food which is already
frozen to avoid temperature rise of
the latter.
Iced products, if consumed
immediately after removal from the
freezer compartment, will probably
cause frost burns to the skin.
It is recommended to label and date
each frozen package in order to keep
track of the storage time.
Hints for the storage of frozen food
Ensure that frozen food has been
stored correctly by the food retailer.
Once defrosted, food will
deteriorate rapidly and should not be
re-frozen. Do not exceed the storage
period indicated by the food
manufacturer.
Switching off your appliance
If the appliance needs to be switched
off for an extended period, the
following steps should be taken
prevent mould on the appliance.
1.Remove all food.
2.Remove the power plug from the
mains socket.
3.Clean and dry the interior
thoroughly.
4.Ensure that all the doors are
wedged open slightly to allow air to
circulate.

Publicité

loading