Sibir GSN 16010 Mode D'emploi page 25

7
Caution!
Care and cleaning
Before maintenance,switch off the appliance and
●
disconnect the mains plug from the mains socket.
Do not clean the appliance with metal objects,steam
●
cleaner,ethereal oils,organic solvents or abrasive cleansers.
Do not use a sharp objects instead of a plastic scraper
●
to remove frost from the appliance.
Installation Important!
For electrical connection carefully, follow the instructions
●
given in this manual.Unpack the appliance and check if
there are damages on it.
Do not connect the appliance if it is damaged. Report
●
possible damages immediately to the place you bought
it.In this case retain packing.
It is advisable to wait at least four hours before connecting
●
the appliance to allow the oil to flow back in the compressor.
Adequate air circulation should be around the appliance,
●
lacking this leads to overheating. To achieve sufficient
ventilation, follow the instructions relevant to installation.
Wherever possible the back of the product should not be
●
too close to a wall to avoid touching or catching warm parts
(compressor,
the instructions relevant to installation.
The appliance must not be locate close to radiators or cookers.
●
Make sure that the mains plug is accessible after the
●
installation of the appliance.
Service
Any electrical work required to do the servicing of the
●
appliance should be carried out by qualified electrician or
competent person.
This product must be serviced by an authorized Service
●
Center, and only genuine spare parts must be used.
1)If the appliance is Frost Free.
2)If the appliance contains freezer compartment.
condenser ) to prevent the risk of a fire, follow