Publicité
Les langues disponibles
Les langues disponibles
Dimension Drawings
Assembly
1. examination
Before starting the actual installation, the device should be checked. In addition to the control of
externally recognizable damage, a function check has to be done. Take out the device from the
packing, get rid of all packing materials and put the device with the back on the floor / table. After
connecting to a power supply, the lighting as well as the function of each stage should be checked.
Please take care that exhaust outlet is open through check.
2. Installation
The hood must be installed on the ceiling.
The hood is attached to the ceiling with 2 mounting brackets.
In order to fasten the mounting brackets to the ceiling, it is necessary to drill 6 holes for wedge
anchors (see dimensional drawings).
Hang the hood on the brackets' hooks.
Then you need to attach the hood to the mounting brackets using 8 screws.
Connect the hood to the power supply unit.
Publicité
