Publicité
Les langues disponibles
Les langues disponibles
B
Using the appliance
Display
Rinse Aid
If the indicator is lit, it means the dishwasher is low
on dishwasher rinse aid and requires a refill.
Warning
8
indicator
Salt
If the indicator is lit, it means the dishwasher is low
on dishwasher salt and needs to be refilled.
Intensive
For heaviest soiled crockery, and normally soiled pots,
pans, dishes etc. With dried-on food.
ECO
This is standard program, it is suitable to clean
Eco
normally soiled tableware and it is the most efficient
program in terms of its combined energy and water
Program
consumption for that type of tableware.
9
indicator
Glass
For lightly soiled crockery and glass.
90 min
90 '
For normally soiled loads that need quick wash.
Rapid
A shorter wash for lightly soiled loads that do not
need drying.
10
Delay time
To show the delay time. (3h/6h/9h)
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
18
EN
B
Using the appliance
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Press the Power button to end the setting mode.
WATER HARDNESS
German
French
British
Mmol/l
dH
fH
Clarke
0 - 5
0 - 9
0 - 6
0 - 0,94
6 - 11
10 - 20
7 - 14
1,0 - 2,0
12 - 17
21 - 30
15 - 21
2,1 - 3,0
18 - 22
31 - 40
22 - 28
3,1 - 4,0
23 - 34
41 - 60
29 - 42
4,1 - 6,0
35 - 55
61 - 98
43 - 69
6,1 - 9,8
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
1)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
19
Regeneration
Water softner
occurs every
consumption
level
X program
(gram/cycle)
sequence
1)
No
H1 -> Rapid Light
regeneration
bright
H2 -> 90 min Light
10
bright
H3 -> Rapid, 90 min
5
Light bright
H4 -> Glass Light
3
bright
H5 -> Rapid, Glass
2
Light bright
H6 -> 90 min, Glass
1
Light bright
EN
Salt
0
9
12
20
30
60
Publicité
