JVC KW-M180BT Guide De Démarrage Rapide page 13

Les langues disponibles

Installation

Ñ Microphone unit

1) Check the installation position of the microphone

(accessory 4).

2) Clean the installation surface.

3) Remove the separator of the microphone

(accessory 4), and stick the microphone to the

place shown below.

4) Wire the microphone cable up to the unit with it

secured at several positions using tape or other

desired method.

5) Adjust the direction of the microphone (accessory

4) to the driver.

Fix a cable with a commercial item of tape.

✎

NOTE

• Swap the clips if necessary.

Ñ Removing the trim plate

1) Use the extraction key (accessory 3) to lever out

the four tabs (two on the left part, two on the right

part).

2) Pull the trim plate forward.

Ñ Removing the unit

1) Remove the trim plate by referring to step 1 in

"Removing the trim plate".

2) Insert the extraction key (accessory 2) deeply into

the slot as shown. (The protrusion at the tip of the

extraction key must face toward the unit.)

3) With the inserted extraction key secured, insert the

other extraction key into the slot.

4) Pull out the unit halfway.

✎

NOTE

• Be careful to avoid injury from the catch pins on

the extraction key.

5) Pull the unit all the way out with your hands, being

careful not to drop it.

English |