Maintenance And Cleaning; Monthly; Troubleshooting - Abicor Binzel WH Mode D'emploi

Alignment jig

7 Maintenance and cleaning

Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.
Danger of crushing
Parts of the body can be crushed between the torch neck and the guide device when aligning the torch
neck during normal operation.
• Keep out of the danger zone.

7.1 Monthly

A monthly basic cleaning is recommended, and necessary in case of extreme working conditions.

8 Troubleshooting

Please observe the attached document "Warranty". In the event of any doubts and/or problems, please
contact your retailer or the manufacturer.
NOTICE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding components, such as the power supply,
Fault
The test block is blocked and
does not return automatically to
the basic position
The torch does not fit into the
clamping device
Tab. 8
BAL.0022 • 2017-02-15
WARNING
welding torch system, coolant recirculator, etc.
Cause
• Spring broken
• Test block soiled
• Clamping body soiled
Troubleshooting
7 Maintenance and cleaning
Solution
• Change the spring
• Clean the test block
• Basic cleaning
EN - 11