Check The Alignment; Adjusting The Bending Angle; Material Damage - Abicor Binzel WH Mode D'emploi

6 Operation

6.1.1 Check the alignment.

1 Unscrew or pull out the gas nozzle and remove other torch-specific fittings.
1
Abb. 4
2 Screw in the measuring sleeve (2) at the position of the contact tip.
The bending angle is correct if the test mandrel (1) fits easily into the bore of the measuring sleeve (2).

6.2 Adjusting the Bending Angle

Material damage

The torch neck can be damaged in case of too frequent and excessive bending.
• Perform only minor corrections.
1
2
Abb. 5
1 Plug on/screw in the adjusting sleeve (3) onto the gas nozzle receptacle.
2 Put the adjusting lever (4) onto the adjusting sleeve (3) and correct the bending angle slightly.
Check the concentricity of test mandrel (1) and measuring sleeve (2) constantly during this procedure.
The bending angle is correct if the test mandrel (1) fits easily into the bore of the measuring sleeve (2).
EN - 10
1
Test mandrel
Checking the Alignment
CAUTION
1
Test mandrel
Measuring sleeve
Adjusting
2
2 Measuring sleeve
2 3
3 Adjusting sleeve
4 Adjusting lever
Alignment jig
4
BAL.0022 • 2017-02-15