Changing The Batteries; Error Messages; Cleaning And Care - SilverCrest SDL 300 C2 Mode D'emploi

Changing the batteries

As soon as the battery becomes low, the " " symbol
will be shown on the display
replace the battery soon. When "
on the display
You should then replace the battery:
♦ Remove the cover of the battery compartment
♦ Take out the empty battery, and replace it with
a new 1.5 V AAA/LR03 battery. Ensure that the
battery has the correct polarity.
♦ Close the battery compartment

Error messages

- "OUTZero": There is already more than 30 g
weight in the spoon
on. Remove the weight from the spoon
switch the appliance back on again.
- „UNSTable": The appliance is not being
held stably/level while being switched on. Place the
appliance on a stable support/hold the appliance
level and still in your hand.
– The batteries are low. The batteries will need to
be replaced soon!
– The batteries are dead. Replace the
batteries!
- Overload! The material in the spoon
heavier than the maximum allowed weight!
Remove some material from the spoon

Cleaning and care

ATTENTION! PROPERTY DAMAGE!
Do not use abrasive or chemical cleaning
materials. These will damage the surface of the
appliance!
♦ Clean the appliance with a damp cloth. For
stubborn soiling use a mild detergent on the
cloth.
NOTE
You can remove the spoon
spoon handle and clean it separately in
the dishwasher.
♦ Ensure that the appliance is properly dry before
re-using it.
│ GB │ IE
■ 20
, the battery is empty.
when the scale is switched
to remind you to
" appears
.
and then
!
from the
SDL 300 C2
.
is