Incremental Weighing; Changing The Measuring Unit; Switching Off; Troubleshooting - SilverCrest HG05706A–E Instructions D'utilisation Et Consignes De Sécurité

possible to activate the product. You can always
press the button TARE
zero point.
Place the item you wish to weigh onto the product.
The numerical display
the item you are weighing.

Incremental weighing

Touching the button TARE
will change the numerical display
reading to "0". The "T" symbol
Note: A slight touch of the button TARE
button UNIT is sufficient to operate the product.
4
If there is too much pressure, the product may
cause tilting.
Now add another item to weigh onto the product.
The numerical display
the newly added item.
If you remove the item added to the product, the
numerical display
If you remove all items from the product, the LC
display will show a negative value indicated
2
by the minus symbol
Then briefly touch the button TARE
symbol will disappear.
10
Important! Be sure never to add more than 5 kg
to the weighing surface
can damage it.

Changing the measuring unit

The product will display the weight in the official Euro-
pean measuring unit "g" (grams), as well as the tradi-
tional unit of weight "oz" (ounce, 1 oz ≈ 28.35 g) or
"lb'oz" (pound: ounce, 1lb = 16 oz ≈ 453.59 g).
When measuring the volume of water, the product
calculates it by the weight using the official European
10 GB/IE/NI
at any time to set the
3
will show the weight of
7
with the product on
3
from the
7
will appear.
10
3
will show the weight of
7
will again read "0".
7
.
9
, and the "T"
3
. Overloading the product
1
unit of volume "ml" (millilitres) or the traditional unit of
measure fl'oz (fluid ounces, 1fl'oz ≈ 28.41 ml).
To switch the unit of measure, briefly touch the UNIT
button . After each time it is touched, the unit
4
display will switch to the next unit listed:
8

Switching off

Holding the button TARE
and the will off the product. If no movement is detected on
the weighing surface
ton is pressed, the product will automatically
switch off.

Troubleshooting

= Fault
= Cause
= Solution
=
= The product is overloaded.
= Remove the overload.
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section "Replacing the
battery").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display
objects away from it.
g → oz → lb'oz → ml → fl'oz
for approx. 3 seconds
3
for 3 minute and no but-
1
indicates a problem, move such
2