Publicité
Les langues disponibles
Les langues disponibles
+
FE.
10 operations
Radi
RQT5238
TUNER/BAND
TUNE a
|
(Pi
UNE
ADJ
With preset stations
Preset channel
With non-preset stations
Received frequency
FM MODE/BP
|
| Listening to radio broadcasts
Ree:
~
Press [TUNER/BAND] to select "FM" or "AM".
The power will come on automatically.
on
The glide panel retracts enabling access
to the operation
buttons.
Each time you press the button; "FM'<—>"AM"
2 Press [TUNE MODE] to select "PRESET" or
"MANUAL".
,
Each time you press the button; "MANUAL"<—> "PRESET"
PRESET:
For preset stations
'
MANUAL:
For non-preset stations
3 Turn [TUNE/TIME ADJ] to the right or left to se-
lect the desired broadcast.
"ST" lights when an FM stereo broadcast is being received.
"TUNED" lights when you precisely tune in a broadcast station.
EY Adjust the volume.
For tuning by remote control
Before tuning, make sure that the desired stations have been preset.
Specify the channei you want with the numeric buttons.
To select channels 1-9
Press the appropriate number.
To select channels 10-15 (two-digit channels)
Press [210] and then the two numbers you want.
For example
Channel 15: [210]—[1]—>[5]
One-touch play
When the system is OFF, the broadcast station last tuned will be re-
ceived automatically when you press [TUNER/BAND].
Auto tuning is an easy way to tune in non-preset stations (select
"MANUAL" in step FE).
Turn and hold [TUNE/TIME ADJ] to the right or left, and
release the [TUNE/TIME ADJ] when the frequency starts
scrolling.
The radio frequency will stop automatically on the first station it picks
up.
eWhen there is outside interference, the radio may stop on a non-
broadcast frequency. Turn and hold [TUNE/TIME ADJ] to the right
or left to resume auto tuning.
To stop auto tuning
Partially turn (TUNE/TIME ADJ] to the right or left to stop scrolling.
If noise is excessive in the FM stereo mode F]
by remote control only
Press [FM MODE/BP]. "MONO" will light up.)
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. "MONO" will go out.
For your reference
,
You can preset FM stations in monaural. Make sure "MONO light
up. Then follow "Presetting only your favorite stations" on page 11 to
preset FM stations in monaural.
'Normally, you'll want to listen in stereo, so leave "MONO" off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
Sound is momentarily interrupted if you operate the cassette deck
while listening to an AM broadcast.
Publicité
