Publicité
Les langues disponibles
Les langues disponibles
DOWN/-
SRUNETNE ADJ |
UP/+
ne
mt eee
ee.
ee
we
re
me me
a m ee ee
eee
eee.
—
Presetting radio broadcasts
Up to 15 stations can each be setin the FM and AM bands automat-
ically.
elf broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
e You can also preset just those stations you like.
(See "Presetting only your favorite stations" below.)
Preset each station in the FM and AM bands with the following
procedure.
Press [TUNER/BAND] to select "FM" or "AM".
The power will come on automatically.
The glide panel
retracts enabling access
to the operation
buttons.
Each time you press the button; "FM" «—"AM"
Press [TUNE MODE] to select "MANUAL".
Each time you press the button;
"MANUAL"<—> "PRESET"
Turn [TUNE/TIME ADJ] to the right or left until
the display shows the frequency from which
you want to begin automatic memory preset-
ting.
Tips on tuning in radio stations
© Turn and hold (TUNE/TIME ADJ] to the right or left until the
frequency starts scrolling.
Continue to hold [TUNE/TIME ADJ].
@) When nearing the desired frequency, partially turn [TUNE/
TIME ADJ] to stop scrolling and then fine tune the broadcast
with slight adjustments to the right or left.
Press and hold [MEMORY] until the frequency
begins to change.
This will start presetting automatically. When finished, the radio
will tune in last station memorized.
+
If the above is not possible because radio signals are weak or
for some other reason, do the following.
| Presetting only your favorite stations
|
Preset the stations one at a time.
1. Perform step E, then press [MEMORY].
2. Select a station with [TUNE/TIME ADJ], and press [MEMORY].
"M" will flash on the display.
3. While "M" is flashing, select a preset channel with [TUNE/TIME
ADJ] and press [MEMORY] again. "M" will go out and the station
will be stored in memory.
FM allocation setting
|
The FM frequency step is set to 0.2 MHz at the time of shipment.
By adjusting the allocation as shown below, you can enable the sys-
tem to receive FM broadcasts allocated in 0.1 MHz steps.
1. Press and hold [TUNER/BAND)] for approximately 5 seconds.
The frequency display will be returned to the minimum frequency
of the FM band and the display will begin to flash.
Keep holding for approximately 5 more seconds.
2. When the display stops flashing and indicates a different frequen-
cy number {The frequency step is changed to 0.1 MHz.), release
[TUNER/BAND).
To return to the original step, repeat steps 1 to 2 above.
After changing the "allocation" setting, the frequencies you previously
preset in the memory will be cleared.
Memory retention
Your preset frequencies are retained in memory for about 2 weeks
while the system is unplugged.
Prepa
DES
">
AQT5238
Publicité
