Télécharger Imprimer la page

Westinghouse iGen5000 Manuel De L'utilisateur page 12

Générateur d'onduleur numérique
Masquer les pouces Voir aussi pour iGen5000:

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY
Fuel can damage paint and plastic. Use caution when
filling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
Clean the fuel screen filter of debris before and after
each fueling. Remove the fuel screen filter by slightly
compressing it while removing it from the fuel tank.
CONNECT THE BATTERY
1. Push down the battery access cover tab and pull the
cover forward to remove it.
2. Verify that the rubber battery strap is firmly securing the
battery in place. If loose, pull on the strap and hook it
onto the mounting base.
12 | English
NOTICE
NOTICE
Note: If the strap is loose behind the battery, remove the
battery, reconnect the strap, replace the battery,
then thread the strap under the battery quick
connect cables.
3. A quick-connect battery plug is pre-installed on the
battery. Remove the cable tie securing the plugs then
push firmly to connect them.
4. Align the tabs on the bottom of the battery access cover
with the generator case then push to reinstall the cover.
Note: The generator is equipped with a battery charging
feature. Once the engine is running, a small charge
will slowly recharge the battery.

Publicité

loading