Publicité
Les langues disponibles
Les langues disponibles
pre-drilled holes. Repeat installation for second leg with wheel (front
side), but also install one front shelf support using the same hardware.
Note illustration 2A for guidance.
NOTE: Front-facing leg with wheel will have two screws pre-mounted
into the leg. This is for bottle opener installation in later step.
•
Mount one stationary leg to the hopper end of the back of main barrel
using four screws, locking washers, and washers, through the four pre-
drilled holes. Repeat installation for second stationary leg (front side),
but also install one front shelf support using the same hardware. Note
illustration 2B for guidance.
NOTE: Fasten screws of the support legs only half-way to allow
easier installation of bottom shelf in next step.
3. INSTALLING THE BOTTOM SHELF
Parts Required:
1
x
Bottom Shelf (#21)
Screw (#A)
4
x
4
x
Locking Washer (#B)
4
x
Washer (#C)
Installation:
•
From underneath, secure the bottom shelf to each leg using a screw,
locking washer, and washer. Ensure the flat surface of the shelf is
facing up towards the grill barrel.
NOTE: Fasten screws of the bottom shelf only half-way all screws
have been installed. Once all screws are installed, then tighten
securely into the legs.
•
Once the shelf is secure, carefully lift the grill into an upright position.
4. SECURING THE LID STOPPER
Parts Required:
1
x
Lid Stopper (#3)
Installation:
•
Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.
5. ASSEMBLING THE LID HANDLE
Parts Required:
1
x
Lid Handle (#8)
Lid Handle Bezel (#7)
2
x
Installation:
•
Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on the
screw, then hand-tighten the screw (from the inside) into the lid handle.
Repeat same installation for other end of lid handle.
8
2B
11
11-1
14
C
A B
14
3
21
A
B C
4
3
5
8
7
11
11-1
Publicité
