Cisco Catalyst 9400 Guide D'installation page 197

Configuration initiale du commutateur
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: examplesecret
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: exampleenable
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: examplevtp
Setup account for accessing HTTP server? [yes]: yes
Username
Password
Password is UNENCRYPTED.
Étape 4 Indiquez si vous souhaitez configurer un compte pour accéder au serveur HTTP.
Exemple :
Setup account for accessing HTTP server? [yes]: yes
Username
Password
Password is UNENCRYPTED.
Étape 5 Indiquez si vous souhaitez configurer la gestion du réseau SNMP.
Exemple :
Configure SNMP Network Management? [no]: no
Étape 6 Le système affiche une liste récapitulative de l'interface. Dans cette liste, saisissez le nom de l'interface utilisé
pour vous connecter au réseau de gestion, puis saisissez l'adresse IP et le masque de sous-réseau de l'interface.
Exemple :
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Vlan1
GigabitEthernet0/0
GigabitEthernet1/0/1
<output truncated>
Enter interface name used to connect to the
management network from the above interface summary: GigabitEthernet0/0
Configuring interface GigabitEthernet0/0:
Configure IP on this interface? [yes]:
IP address for this interface: 192.168.247.10
Subnet mask for this interface [255.255.255.0] : 255.255.0.0
Class C network is 192.168.247.0, 16 subnet bits; mask is /16
The following configuration command script was created:
hostname Switch
enable secret 5 $1$2EYv$CSkmxAlgDon2AKcfXNNwT/
enable password exampleenable
line vty 0 4
password examplevtp
[admin]:
[cisco]:
[admin]:
[cisco]:
IP-Address
unassigned
unassigned
unassigned
Guide d'installation matérielle des commutateurs Cisco Catalyst 9400
OK? Method Status
NO unset up
NO unset up
YES unset down
Effectuer la configuration initiale
Protocol
up
up
down
191