Cisco Catalyst 9400 Guide D'installation page 106

Removing a Fan Tray from the Front
1 Captive installation screws on the front panel
of the fan tray in the chassis
Étape 4
Grasp the fan tray handle and pull it out only partially (0.25 inches), to unmate the connector and unseat it
from the backplane. After unmating the connector, allow three seconds to let the fan blades stop spinning
completely.
Guide d'installation matérielle des commutateurs Cisco Catalyst 9400
100
Retirer et remplacer des unités remplaçables sur site
- -