Publicité
Les langues disponibles
Les langues disponibles
Page 8 of 19
•
Refit the indicators to the tail tidy (ITEM 1), by gently pushing the indicator into the two profiled slots on the
bracket (shown in Picture 19) NOTE: some washing up liquid may help with this. Be sure to reuse the plates,
washers, and plastic inserts removed during a previous step.
If fitting mini indicators (Ignore this section if fitting OEM indicators)
•
Slide two lengths of heat shrink (ITEM 11) over the exposed wiring of the mini indicator, and heat gently to
shrink it.
•
Slide one of the indicator adaptors (ITEM 3) over the thread of the mini indicator, ensuring the profiled side of
the adaptor is outward facing.
•
Insert the assembly into the profiled slot in the tail tidy (ITEM 1), highlighted in Picture 19.
•
Then slide another indicator adaptor (ITEM 3) over the thread, ensuring the profiled edge goes into the profiled
slot in the tail tidy.
•
Secure the mini indictor in position using the M8 nut provided.
•
Connect one of the Indicator connectors (ITEM 9) to the end of mini indicator using the bullet connectors.
•
Repeat the steps above for the other indicator.
NOTE: 1 x set of RGR0001 resistors (available separately) may be required to achieve the correct flash rate.
•
Slide two lengths of heat shrink (ITEM 11) over the exposed wiring of the licence plate illuminator assembly
(ITEM 2), and heat gently to shrink it.
•
Fit the licence plate illuminator assembly (ITEM 2) to the tail tidy (ITEM 1) using the bolts, washers and nuts
provided. Please note you will have to fit the light shroud and use a small amount of adhesive to hold it in
position.
Connect the licence plate illuminator connector (ITEM 8) to the end of the licence plate illuminator using the
•
bullet connectors.
Neatly secure the wiring to the tail tidy (ITEM 1) using the cable ties (ITEM 10) in the holes arrowed in Picture
•
20.
NOTE: Ensure the wiring passes through the large hole at the top of the tail tidy.
•
Slide the rubber gasket (ITEM 4) over the wiring and position it so the four mounting holes line up.
•
Offer the assembly up and feed the wiring through the bike, following the same route as the original wiring.
•
Secure the tail tidy in place using the M6 bolts, washers and nyloc nuts (as shown in Picture 21).
Connect the indicator and licence plate illuminator connectors to the wiring loom.
•
•
Refit the bolts removed in Picture 10, luggage rack, two side fairings and seat.
•
Refit the licence plate to the tail tidy (ITEM 1) (it may require drilling).
•
Please check the operation of all lights before riding the motorcycle. If illumination fails swap the bullet
connectors.
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR DOWN ON
•
THE LICENCE PLATE HANGER, THERE IS A SMALL CHANCE OF THE LICENCE PLATE
HITTING THE BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD.
IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE AVOIDING
ACTION. FAILURE TO CHECK THIS COULD RESULT IN SERIOUS INJURY.
•
Depending on local laws, attach enclosed reflector (ITEM 12) in an appropriate location.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 23/01/2019 (LF)
R&G
www.rg-racing.com
Email:
info@rg-racing.com
LP0263
Publicité
