Publicité
Les langues disponibles
Les langues disponibles
Page 7 of 19
FITTING INSTRUCTIONS
•
Remove the seat, using the lock under the tail.
•
Remove the bolts/clip arrowed in Pictures 2-6, and carefully remove the LH side fairing.
•
Repeat on the RH side (shown in Picture 7).
With both side fairings removed, remove the four bolts arrowed in Picture 8, and carefully remove the luggage
•
rack.
•
Use a Philips screwdriver to remove the two bolts arrowed in Picture 9.
•
Remove the two bolts arrowed in Picture 10.
Repeat on the other side.
•
•
Locate the licence plate illuminator and indicator connectors (arrowed in Picture 11) and disconnect them
(shown in Picture 12).
•
While supporting the licence plate mount, remove the four bolts shown in Picture 13.
Carefully feed the wiring through the bike, taking note of the route (Picture 14).
•
•
Remove the licence plate mount from the bike.
If fitting OEM indicators (Ignore this section if fitting mini indicators)
•
With the licence plate mount removed, remove the bolts arrowed in Pictures 15-17.
•
Carefully separate the two halves of the licence plate mount, shown in Picture 18.
•
Before removing the indicators, take note which indicator is LH and RH.
•
Using a Philips head screwdriver, remove the bolt on the rear of the indicator.
•
Carefully remove the OEM indicator (making sure any plates, washers, and plastic inserts are put to one side for
later use) by gently pulling it out of the licence plate mount.
•
Repeat for the other indicator.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 21
R&G
www.rg-racing.com
Email:
Picture 22
info@rg-racing.com
LP0263
Publicité
