S&P TD-500/150-160 SILENT ECOWATT CAV Mode D'emploi page 12

Ensure system operation is safe in event of power
cut/power outage/disruption to power supply. If
ventilation is stopped due to disruption to power
supply, ensure no risk due to excessive tempera-
EN
ture (electrical heater). Care may be needed when
restarting fan after disruption to power supply.
Most motors are supplied with permanent-
ly greased or sealed for life bearings and do not
require re-lubrication. However, if motors with
re-greasing facility are supplied, then follow the
instructions in the specific motor Instruction man-
ual and nameplate supplied.
Warning: Do not mix different types of grease.
MAINTENANCE, REPAIRS
Maintenance/repairs must be carried out by
competent personnel and in accordance with
applicable International, National and Local reg-
ulations. Fan equipment should be electrically
isolated and locked out before any work started.
Fan equipment should be regularly cleaned,
frequency depending upon service load and ap-
plication, but no less than every 6 months. Fan
equipment for dust applications may require more
frequent cleaning to ensure safe operation. Clean-
ing should include all areas where dust can accu-
mulate in the fan equipment.
Special attention should be made to any unusual
sounds, vibration or temperature. If any problems
are detected the fan equipment should be stopped
immediately and cause inspected. The impeller
and blades should be regularly checked for dam-
age that could cause imbalance in the moving
parts.
REPLACEMENT PARTS
Do not start working until all relevant safety
procedures have been read, understood and ac-
tioned correctly.
Ensure that personnel are competent for work
required, spare parts are correct for application,
tools and materials to be used are available and
safe for environment.
Identify components, bolts, fixings to be removed,
and identify location to ensure replaced in same
location, this can be done by marking with num-
ber/letter/colour to bolt fixing and any associated
spacing material to identify location. This is espe-
cially important for motor fixings to supports, and
impeller shaft fixings to supports, where packing/
spacing/shim material is used to adjust motor/im-
12
peller shaft center line, and hence final impeller
position.
GOOD PRACTICE, GOOD/BAD INSTALLATION
ARRANGEMENT
Fans should be installed correctly without any
adverse installation effect. Typically fans should
be installed so that air entry is clear, unobstruct-
ed, non-turbulent and discharge does not hinder
airflow, since air turbulence adversely affects
impeller performance.
PUTTING OUT OF SERVICE AND RECYCLING
Disposal must be carried out by competent per-
sonnel and in accordance with applicable Interna-
tional, National and Local regulations.
Isolate fan equipment and any associated elec-
trical equipment and lock off. Remove electrical
connections.
Disconnect fan equipment from duct connections
and cover connections with plastic sheet to pre-
vent exposure to any residue material in fan equip-
ment, and any contamination of ducts.
Dismantle and dispose in accordance with appli-
cable National and International laws and regula-
tions, those parts whose service life has expired.
EEC legislation and our consideration of
future generations mean that we should
always recycle materials where possi-
ble; please do not forget to deposit all
packaging in the appropriate recycling
bins. If your device is also labeled with
this symbol, please take it to the nearest Waste
Management Plant at the end of its servicable life.
The fan unit is mainly made of steel, copper, fer-
rite, aluminium and plastic. These components
should be recycling in the following categories:
• Steel and iron
• Aluminium
• Non-ferrous metals
• Plastics
• Insulating materials
• Cables
• Electronic scrap
To clarify any questions regarding S&P products
contact your local distributor. For its location and to
obtain the EU Declaration of Conformity and certified
technical data see our web site www.solerpalau.com