Happy Garden ADELAIDE Mode D'emploi page 20

ADELAÏDE
TRA10PREM
Assemble and secure each leg extension tube (F) with the W-foot (E) using the screws
1
(N), washers (P) and nuts (O) as shown in the diagram below.
Assemble the contour structure tubes (D) together using the T-connectors (L).
2
Continue assembling the tubes (D) until you form a circle with all the tubes. Two people
are needed to secure the opposite ends of the circle: each adult must hold one part of
the circle to fit them firmly together.
Caution: the wide end of tube (D) must be inserted before the narrow end of the other
tube.
38
ADELAÏDE
TRA10PREM
3
4
happy-garden.fr happy-garden.fr
Attach the legs to the metal frame of the trampoline circle by inserting them into the
T-connector (L).
CAUTION: Failure to follow these instructions may result in spring failure and structural
deformation.
THE SPRINGS MUST BE ATTACHED AS SHOWN BELOW:
Ensure that the spring hooks are positioned facing the ground.
The spring hooks must be firmly inserted into the holes in the frame.
Place the trampoline jumping mat (A) in the middle of the frame.
CAUTION - Be sure to wear gloves to protect your hands.
Use the spring mounting tool (K) provided in the package.
Hold the springs so that the hooks are aligned with the holes in the frame.
Hold the spring mounting tool in one hand and stretch the spring hooks towards the metal frame
(as shown in the diagram below).
Insert the hooks into the holes in the frame until they are securely held.
BE CAREFUL WITH FINGERS (RISK OF PINCHING) USE GLOVES.
MAKE SURE THAT THE SPRINGS ARE COMPLETELY DRY BEFORE MOUNTING THEM ON THE
STRUCTURE
39