Moulinex fresh express max DJ810510 Mode D'emploi page 14

• Insert the food through the feeder tube (D) and push the food down gently using the pusher
(C) (fig. 5).
TIP: There is no need to press down hard on the pusher to obtain good slicing results; this
type of use will slow down the motor; simply ensure that the ingredient remains in contact
with the cone.
• To change the cone, turn the holder (D) a quarter turn to the right (fig. 6), then return it to
the upright position (fig. 7). Remove the cone (fig. 8).
RECOMMENDATIONS FOR USE
The slow speed is intended for hard foods (e.g. parmesan, chocolate) to be grated with cone E3
(yellow).
The slow speed is also recommended for soft or fragile foods (pears, avocadoes, cooked beetroot).
Fitting the dicing accessory:
• Place the dicing cone in the opening at the front of the holder (D), the cone should be correctly
positioned all the way into the drive (fig. 3).
• Then position the dicing ring with the safety flap open, centring the safety hinge on the cone
holder tube (fig. 9).
• Check that the dicing ring is correctly attached to the base of the cone holder.
• Close the safety hinge over the cone holder (fig. 10).
• Use the dicing function by inserting the ingredients through the cone store feeder.
• Remove the dicing accessory by pulling the tab positioned at the top of the safety hinge
(fig. 11).
Tip: to unlock the safety hinge E5b more easily, move it upwards with one finger while
simultaneously pulling the tab forward (fig.11).
F.A.Q.
Questions
• "The Cone is not properly held in
place in the holder, I can't hear a
click".
• "I can't remove the accessory after
use".
• "The cone holder is quite hard to
fit and remove, is this normal?"
Simply make sure that the cone is slotted all the way
onto the drive (fig. 3). Press the on/off button first
before inserting food into the feed tube to ensure the
cone is correctly locked into place (fig. 4).
To remove the cone after use, unlock (fig. 6) the holder
then relock it (fig. 7) and the cone will fall out by itself
(fig. 8).
Yes when the appliance is new. With use it will become
easier to install and remove.
Answers
EN EN
9