Vortice CA V0 Notice D'emploi Et D'entretien page 9

ENGLISH
Description and use
The unit you have purchased is an axial centrifugal
aspirator for air expulsion in ventilation ducts. It is
constructed of plastic self-extinguishing material V0, is
protected against sprays of water, and is equipped with
ball bearings, which guarantee at least 30,000 hours of
mechanical operation and constant silence over time.
IMPORTANT : The unit is able to develop 3 ventilation
speeds, as it is already equipped with suitable
condensers. Operating speed control is designated to
pairing with an appropriate 3-speed selector. For
further information regarding the control device, see
the "Wiring diagrams" paragraph.
These appliances are designed
for use in
commercial properties.
Safety
Warning:
!
this symbol indicates that care must
be taken to avoid injury to the user
• Always use the product for the purpose it was
intended, as specified in this booklet.
• After removing the product from its packaging, ensure
that it is not damaged. If in doubt please contact a
Vortice authorised Technical Assistance Centre
immediately. Never leave packaging parts within
reach of children or disabled persons.
• The use of any electric device requires compliance
with a few fundamental rules, including:
- Never touch it with wet or humid hands.
- Never touch it when barefoot.
- Do not allow use by unsupervised children or
disabled persons.
• Do not use the unit in the presence of flammable
substances or vapours such as alcohol, insecticides,
gasoline, etc.
This appliance can be used by
•
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
Children shall not play with the
•
appliance.
Cleaning and user maintenance
•
shall not be made by children
residential and
without supervision.
Precautions must be taken to
•
prevent gas coming from the gas
flue pipe or from other fuel
combustion units from entering
into the room.
Products installed without a
•
protective device for moving
parts must be installed at a
height greater than 2.3 m above
the floor level.
Unit is equipped with manual
•
reset thermal breaker device: in
order to avoid any danger of
accidental reset of the thermal
breaker device, units must not
be powered by an external
switch device such as a timer, or
must not be connected to a
circuit that is regularly powered
or disconnected from power
utilities.
If the power cable is damaged, it
•
must be replaced
manufacturer or its technical
assistance service or in any
case by a similarly qualified
person, in order to prevent any
risk.
by the
9