Publicité
sacoche à l'arrière de la moto, et remettre les boulons d'origine (Photo 13). Les supports
supérieurs de la plaque de fixation de la sacoche se placent sur le haut de la queue de support
comme indiqué. Assurez vous que les boulons soient serrés de façon égale et que les fils soient
bien tous attachés dans la protection et que les points de fixation soient libres lorsque le serrage
complet est fait.
Remettre le siège passager.
Remettre la plaque d'immatriculation (peut nécessiter un perçage).
IMPORTANT: Si vous installez une grosse plaque, il y a un risque que la plaque entre en contact
avec la roue arrière en cas de choc sur la route (bosse, grosse charge etc...). Il est de votre
responsabilité de vérifier que cela ne puisse pas se produire. Ne pas effectuer ces vérifications
peut entrainer des dommages ainsi que des blessures graves pour le pilote.
Selon la loi locale, monter les réflecteurs (article 10) aux emplacements appropriés.
Revérifiez que les clignotants et les feux de plaque fonctionnent bien avant de prendre la route.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its
particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any
fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable
condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc.
P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued
products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 23/05/13 (AR)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
