Bort TITAN 4000 Mode D'emploi page 14

flammable vapor-gas mixtures and liquid near
the disposer . Do not allow the following camera
products: paints, solvents, household cleaning
agents and chemicals, automotive liquids, plastic
packaging .
USER'S MANUAL
1 . Use air switch (Fig . 11 .1) for starting disposer .
2 . Slowly lower food waste into the chamber and
install the filter grid in a vertical position (so that it
flows through it water) to reduce noise and possible
throwing waste during grinding (Fig .11 .2) .
3 . After the grinding is completed, turn off the
disposer and let the water run for at least 15 s to
flush the drain line.
SHOULD . . .
• Grind food waste under pressure cold water not
less than 6 liters / min .
• Grind solids, such as small bones and fruit
residues, for cleaning chopping chambers .
• Grind citrus fruits, melons, vegetables and coffee
beans .
• After the grinding is finished, let the water run out
at least 15 seconds to flush the drain pipeline.
• Unplug the product from the socket before
removing the seized rotor with a tool .
• Do not store any objects under the display to
ensure access to the button restart .
DO NOT...
• Do not use hot water when grinding remains of
products (although hot water through the product
between grinding) .
• Do not turn off the water or the product until the
grinding is completed, there is a noise of running
engine and running water .
• Do not grind large amounts of egg shells, fibrous
materials, for example corn husks, artichokes, etc .,
in order to avoid possible clogging of the pipe .
• Grind only food .
• Do not use this appliance to grind hard materials,
such as glass and metal .
• Never pour fat, oil or fat in shell, as this will lead to
clogging drainage and sewerage systems .
• Do not fill the disposer chamber with a large
amount of cleaning vegetables . Instead, turn on
the water first and disposer and gradually lower it
cleaning .
CLEANING THE DISPOSER CHAMBER
Over time, fat / food particles can accumulate
in the grinding chamber and protective reflector,
causing an unpleasant smell
For cleaning grinding chamber and reflector:
1 . Turn off the EQUIPMENT and disconnect it
from the mains .
2 . Through the drain hole using a sponge for
washing, clean the bottom surfaces protective
reflector and inner upper edges of chopping
chamber .
3. Place the plug in the drain hole and fill the sink
with hot water halfway .
4 . Mix 60 ml of baking soda with water . Turn the
product on and remove the plug from the sink .
washing of foreign particles .
ELIMINATION OF JUMMING DISPOSER
If during the operation of the disposer motor
stopped, possibly jammed moving parts .
To eliminate jamming:
1 . Turn off the power of the disposer and shut
off the water .
2 . Insert one end of the wrench into the center
hole on the bottom of the product for a self-
contained removal of stuck waste (Fig .11 .5) .
Turn the wrench back and forth until as long as
he will not make one full turn . Take out wrench .
3 . Remove foreign objects from the help ticks
with long handles . Give to the engine of the
product cool for 3-5 minutes and press the
red reset button on the bottom of the disposer
(Fig .11 .6) (If the engine does not start, check
the protective shield for the presence of circuit
breakers and burnt out fuses) .
SERVICE
If you need to perform maintenance or repair the
product, contact an authorized service center or to your
dealer .
The warranty is canceled in the following cases:
- if the product was used with impairments requirements
of this manual
- in the presence of traces of the opening of the body of
the product for self-repair
For more details about the terms and conditions of the
warranty, see the warranty coupon .
14