Bestway Lay-Z-Spa Serie Manuel Du Propriétaire page 6

Selected Location
WARNING: The selected location has to be able to support of supporting the
expected load.
WARNING: An adequate drainage system has to be provided to deal with overflow
water for both indoor and outdoor installations.
IMPORTANT: Because of the combined weight of the Lay-Z-Spa, water, and users, it
is extremely important that the base where the Lay-Z-Spa is installed is smooth, flat,
level and capable of uniformly supporting the weight for the entire time the Lay-Z-Spa
is installed (not on the carpet or other similar material). If the Lay-Z-Spa is placed on
a surface, which does not meet these requirements, any damage caused by
improper support is not covered under the manufacturer's warranty. It is the
responsibility of the Lay-Z-Spa owner to assure the integrity of the site at all times.
1. Indoor Installation:
Be aware of special requirements if you install the spa indoors.
• Humidity is a natural side effect with Lay-Z-Spa installation. Determine the effects of
airborne moisture on exposed wood, paper, etc. in the proposed location. To
minimize these effects it is best to provide plenty of ventilation to the selected area.
An architect can help determine if more ventilation is needed.
2. Outdoor Installation:
• During filling, draining or when in use, water may flow out of the spa. Therefore the
Lay-Z-Spa should be installed near a floor drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.
PRCD Test
RESET
RESET
TEST
TEST
1
NOTE: Drawings for illustration purpose only. May not
reflect actual product. Not to scale.
1. Insert the plug.
2. Press the "RESET" button, the indicator light turns on.
3. Press the "TEST" button, the indicator light turns off.
4. Press the "RESET" button, the indicator light turns on.
5. Press the "On/Off" button for 2 seconds, your pump is ready to use.
WARNING: The PRCD plug must be tested before each use to avoid risk of electric
shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of
the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Aftersales Service.
NOTE: When inflating, you will notice that air will be expelled from the area where
the air hose connects to the pump, this is normal for technique requirements.
NOTE: Do not use an air compressor to inflate the pool.
NOTE: Do not drag the pool on rough ground as this may cause damage to the pool liner.
NOTE: Inflation time for reference only.
NOTE: Pressure gauge is for inflation purpose only,
and the value of the pressure gauge is just for
reference, should not be used as a precision instrument.
INSTALLATION
RESET
RESET
TEST
TEST
2
3
6
4
S-S-005125