Bestway Lay-Z-Spa Serie Manuel Du Propriétaire page 10

Air-Valve Adjustment (For quick inflation/deflation valve Only)
In case of air leakage, check the air-valve first. Using soapy water, cover the air-valve to check if air is leaking, if so, use the
provided wrench to fasten the air-valve following these steps:
• With one hand, hold the backside of the air-valve from the inner side of the spa wall and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Always check the air-valve carefully before use.
3. Do not adjust the air-valve connector when the spa is in use.
STORAGE
Draining the Spa
2.
1.
6. 7.
Detergent residues and dissolved solids from bathing suits and chemicals may build
Cleaning the spa
up on the spa walls. Use soap and water to clean the walls and rinse thoroughly.
NOTE: DO NOT use hard brushes or abrasive cleaners.
DEFLATION
1.
P61726
2.
Screw valve
P61727
REPAIR
For PVC part.
If the spa is torn or punctured, use the provided heavy-duty repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 seconds before inflation.
3. 4.
NOTE: Lift up the spa when there is
only a little water left. Damages to
the handles are not covered under
the warranty.
P61726
P61725
P61727
Quick inflation/deflation valve
P61725
For Tritech PVC material.
If the spa is torn or punctured, use the provided PVC repair patch and
glue (not included) following these steps:
1. Clean and dry area to be repaired.
2. Cut the provided PVC patch to appropriate size.
3. Use glue (not included) to coat the one side of the newly cut patch.
Make sure the glue is evenly distributed.
4. Wait for 30 seconds and then place the cut patch with glue over the
damaged area.
5. Smooth out any bubbles of air that may be trapped underneath,
and press firmly for two minutes.
6. The product is once again ready for use. Repeat this process
should further leaks occur.
7. Wait 30 minutes before inflation.
10
5.
P6932
P6611
8. NOTE: Dry the spa pool
Safety valve
2
S-S-005125