Publicité
Les langues disponibles
Les langues disponibles
4.9.7 Menu H: STOP-A settings
1. Select menu item "H".
ð After approximately 2 seconds, the display flashes and shows the set
value of the operating mode. The factory setting is "0".
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) but-
tons.
Value
Description
0
1
3. Press the programming button (PROG button) (D).
ð The display shows "0". End of menu (if necessary, continue with power
learning cycle).
4.10
TTZ guideline - Burglar resistance for garage doors
In order to comply with the TTZ guideline, corresponding accessories are neces-
sary for increased burglar protection. These accessories can be ordered separ-
ately. Please use our Secü Kit and follow the instructions WN 020690-45-5-32.
Also follow the instructions WN 902004-21-6-50 as installation instructions for
TTZ guideline burglary resistance for garage doors.
4.11
Completing the installation procedure
Close the cover of the drive head.
Check if the garage door operates properly and safely. See chapter "Mainten-
ance / Checks".
4.12
Attaching the warning sticker
Place the sticker clearly visible on the inner surface of the garage door.
WARNING: Automatic door – Do not stand in the movement area of the door,
because it may start unexpectedly!
Automatic Door
WARNUNG: Automatisches Tor - Nicht im Bewegungsbereich des
Tores aufhalten, da sich das Tor unerwartet in Bewegung setzen kann!
WARNING: Automatic door - The door may operate unexpectedly,
therefore do not allow anything/anyone to stay in the path of the door!
Remarks
ENS-S 8200 or Extra 412 (with 8k2 resistor) connected to STOP-
A input (terminal G)
Jumper or ENS-S 1000 connected to STOP-A input (terminal G)
EN - 67
Publicité
