Publicité
Les langues disponibles
Les langues disponibles
Menu value
7
8
9
3. Press the programming button (PROG button) (D).
ð The display shows "9".
4.9.5 Menu 9: Setting other operating modes
1. Select menu item "9".
ð After approximately 2 seconds, the display flashes and shows the set
value of the operating mode. The factory setting is "0".
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) but-
tons.
Value
Description
0
Normal operation
1
Normal operation with
ventilation settings*
2
Partial opening with side
sectional door*
5
OPEN-CLOSE operation
6
Automatic closing ("AR")** A pulse always causes an opening of the door. After the open
7
Automatic closing ("AR")** Function as in point 6, however, an interruption of the
8
Automatic closing ("AR")** Function as in point 7, however, a pulse during open time
9
Automatic closing ("AR")** Function as in point 8, but without early warning phase.
Remarks:
•
*: The second button of the transmitter must be reset after changes in operating modes 1 or 2.
•
**: A photoelectric sensor must be installed.
Door type
Industrial door with standard fittings
Side section door (Topspeed)
Side section door with secondary closing edge
Note
Factory settings
Allows the ventilation of the garage. In this mode, the garage
door is approximately 10 cm wide open. To start up the
ventilation setting, press the second button on the hand
transmitter or use a DuoControl/Signal 111 (accessories)
setting* that must be programmed in menu 2. The garage door
can be closed at any time using the hand transmitter. The
garage door closes automatically after 60 minutes.
In this mode, the garage door is approximately 1 m wide open.
To start up the partial opening, press the second button on the
hand transmitter or use a DuoControl/Signal 111 (accessories)
setting* that must be programmed in menu 2.
After pulsing in CLOSE position, the drive starts and the door
moves into end position OPEN. Another pulse during upward
motion has no effect and the door continues to open. After
generating a pulse in OPEN position, the door closes. When
generating a pulse during closing, the door stops and opens
again.
time and warning time (setup menu A) the door closes
automatically. An interruption of the photoelectric sensor
during closing causes stop and reverse direction. Interruption
during opening has no effect.
photoelectric sensor during open time causes early termination
of open time and the warning time starts.
causes early termination of open time and the warning time
starts.
EN - 65
Publicité
