PNI HOUSE AHD1250 Manuel Utilisateur page 16

EN
UPNP
The UPNP protocol is used to make automatic forwarding to the router. To use this feature make
sure this option is also enabled on the router.
Enable select the option to enable UPNP settings
HTTP Port: Routing will automatically distribute the device's HTTP port, but monitoring via
Internet Explorer will also need to enter this port.
TCP Port: The router will automatically distribute the device's TCP port, but monitoring CMS will
require this port.
Mobile Port: The router will automatically distribute the device's Mobile port
but when you monitor over the phone you will need this port.
1.3.5 PTZ Config
The function is not active for this kit.
1.3.6 RS232
The function is not active for this kit.
1.3.7 Tour
Activate this function to view a tour of all channels according to the set interval.
1.3.8 Digital
The Digital Interface displays the number and type of cameras supported by this model:
16