Mitutoyo BA9700 Manuel D'utilisateur page 15

14
Data Logger (D-LOG)
15
Factory Settings (RESET) Reset the device to factory settings
16
Vibration (VIBRAT) Activation and deactivation of tactile feedback
ERR06 Tolerance limit outside the permissible range
OFFSET outside the permissible range. The device must be sent to the service centre to correct
ERR07
this error (ERR 07).
ERR08 Reference point in "Relative Mode" outside the display range
ERR09 No communication with the PC or peripherals
ERR10 Communication breakdown during data transfer
Bluetooth connection information has been lost, remove the gauge from all paired devices and
ERR11
start pairing again!
ERR12 Bluetooth connection could not be established after 30 sec., start pairing again!
Key(s) blocked or keyboard defective! Please make sure that the keyboard is not being operated. If
ERR13
the error persists, please contact the service center.
14.1 ON Activating the data logger
14.2 PRINT Printout of the saved measurement values
14.3
D-OUT Transferring the measurement values to connected peripherals
RESET Resetting the D-LOG memory
14.4
14.5 OFF Deactivating the data logger
Error Messages
15