Mitutoyo BA9700 Manuel D'utilisateur page 14

see page 45 for a graphical representation of the functions
Initial State The initial state is a prerequisite for the functioning of all the programs and setting
1
options described.
2
Absolute and Relative Mode Switching from "Absolute Mode" to "Relative Mode"
3
Measuring Programs Switching measuring programs (MIN/MAX/HOLD)
4
Tolerance Program (TOL) Activation and deactivation of the tolerance function
4.1
4.2
4.3
5
Key Lock Deactivation of the key lock. (Key lock reactivates after 20 seconds!)
6
Data Logger (D-LOG) Use Storage of measured values in the internal memory of the device
7
Back Button One-step jump back
8
Setup Menu
8.1
8.2
9
10
11
12
13
14
Accessing the tolerance range selection
Selection and confirmation of the tolerance range
Deactivation of the tolerance function
Accessing the setup menu
Switch between menu items and selection
Zero Point Correction (OFFSET) Setting the offset value
Tolerance Program (TOL) Setting the tolerance limits
Selecting the tolerance range
10.1
Setting the lower tolerance limit (TOL LO)
10.2
Setting the upper tolerance limit (TOL UP)
10.3
Switching MM/INCH (UNIT) Selection of the unit of measurement
Choice of Scale Division Value (SCALE) Selection of the scale resolution
Auto-Power-OFF (A-OFF) Selection of the time after which the device switches to
standby