TEFAL EXPRESS GV7165 Mode D'emploi page 10

1800114819-centrale_vapeur_express.qxd:Mise en page 1
PROBLEMS
The soleplate is dirty or brown and may stain
the linen.
There is no steam or there is little steam.
The red "water tank empty" light is on.
Steam escapes from the rinse plug.
Steam or water escapes under the appliance.
If you have any problems or queries please call our Customer Relations team first for expert help and advice:
CAUSES
You are ironing at too high a
temperature.
You are using starch.
The water tank is empty (red light on).
The steam output control dial is set at
minimum.
The soleplate temperature is set to the
maximum.
The water tank is empty.
The rinse plug has not been tightened
correctly.
The rinse plug seal is damaged.
The generator is faulty.
0845 602 1454 - UK
(01) 677 4003 - Ireland
or consult our website - www.tefal.co.uk
9/02/09
SOLUTIONS
See our recommendations regarding
temperature control setting.
Always spray starch on the reverse side
of the fabric to be ironed.
Fill the water tank.
Increase the steam output (control dial
on the control panel).
The generator is working but the steam
is very hot and dry. As a consequence, it
is less visible.
Fill the water tank.
Tighten the rinse plug correctly.
Contact an Approved Service Centre to order
a new rinse plug seal.
Stop using the generator and contact an
Approved Service Centre.
16:11
GB
D
F
NL
I
P
DK
S
FIN
N
GR
TR
PL
CZ
SK
SLO
RO
H
SR
HR
BG
RF
9