Operating Instructions - Danby DPAC120090 Guide D'utilisateur

CONTROL
PANEL
2
3
Right Side:
1) Temp. Increase (top), Temp. Decrease (bottom) buttons: Press to increase or decrease the
set temperature by one degree (+/- 1°).
2) Mode Indicators: Indicates which operation has been selected. From left to right: Cool, Dry,
Fan, or Heat.
3) Mode Selection Button: Pressing rotates through the available operations.
4) Ionizer Indicator: When lit, the ionizer is energized and operational.
5) Power Supply Indicator: When lit, the machine is recieving power; if blank, the machine is
not receiving power.
6) Fan Speed Indicators: Indicate which fan speed is in use. Options are between High,
Medium, or Low fan speed (varies between operations).
7) Fan Speed Selection Button: Pressing alternates between available fan speeds (some
operations only).
8) Power On Off Button: Pressing activates or deactivates operation of the machine.
Note: To disconnect power completely, the power cord must be removed after deactivating the
machine.
DIRECT DRAIN
To direct drain the unit:
1) Stop, unplug and then locate the unit near a floor drain.
2) Connect a standard garden hose to the upper drain outlet (for location see
Part Identification: Rear # 4).
3) Place the open end of the hose over a floor drain.
4) Reconnect power to the unit.
Draining the Unit:
1) Stop, unplug and then locate the unit near a floor drain (if available; if not
see below note).
2) Place the open end of a garden hose over the floor drain.
3) Remove the lower drain outlet plug (for location, see Part Identification:
Rear # 7) and quickly connect a garden hose to the lower drain outlet.
NOTE: If a floor drain is unavailable, turn the unit off and place a pot or pan directly
beneath the lower drain outlet and then remove the lower drain outlet's plug (this will
cause any stored water to exit the drain outlet). Do not leave the unit unattended while
it is draining in case the pot or pan fills and needs to be replaced.

OPERATING INSTRUCTIONS

FEATURES
Left Side:
1) Display Window: Shows the set temperature (in
°C or °F) and the Auto-timer settings.
2) Timer On (left) & Timer Off (right) indicators.
1
3) Remote receiver.
4) Timer On (left) & Timer Off (right) buttons:
Press the Timer On button to initiate the Auto-On
program, or the Timer Off button to initiate the
Auto-Off program, and is also used to make
adjustments to the Auto-On and Auto-Off timer
settings.
5) °F (left) / °C (right) indicators: Indicates which
scale of temperature is being shown in the display
window.
5
4
Before proceeding with dry mode (on following page), it is required that
you set up a direct drain for the unit.
6