Operating Instructions - Danby DPA120B1WB Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

ELECTRONIC CONTROL
INSTRUCTIONS (con't)
OPERATING MODES
COOL mode
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the ADJUST buttons "up + " or "down - " to select your desired
room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-86°F.
- Press the "FAN SPEED" button to choose the fan speed.
HEAT mode (select models only)
- Press the "MODE" button until the "HEAT" indicator light comes on.
- Press the ADJUST buttons "up +" or "down -" to select your desired
room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-86°F.
- Press the "FAN SPEED" button to choose the fan speed. For some
models, the fan speed can not be adjusted under HEAT mode.
AUTO mode
- When you set the air conditioner in AUTO mode, it will automatically
select cooling, heating (select models only) or fan only operation
depending on what temperature you have selected and the room
temperature.
- The air conditioner will adjust the room temperature automatically to
the temperature point set by you.
- Under AUTO mode, you can not select the fan speed.
FAN operation
- Press the "MODE" button until the "FAN" indicator light comes on.
- Press the "FAN SPEED" button to choose the fan speed (1 time for LOW,
2 times for MEDIUM, 3 times for HIGH, 4 times for AUTO-FAN).
- The corresponding fan speed indicator light for each speed lights up. All
three indicators are lit up when AUTO-FAN is selected.
- The temperature cannot be adjusted.
- Do not use the window hose in this mode.
TIMER operation
- To initiate the "Auto-stop" program: When the unit is on, press the Timer
button, the TIMER OFFindicator light will illuminate.
- To initiate the "Auto-start" program: When the unit is off, press the Timer
button, the TIMER ON indicator light will illuminate.
- Press or hold the "UP " or "DOWN " button to change the Auto time by
0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24
hours.The control will count down the time remaining until the unit starts.
- The selected time will register in 5 seconds and the system will
automatically revert back to display the previous temperature setting.
- Turning the unit ON or OFF at any time or adjusting the timer setting
to 0.0 will cancel the Auto Start/Stop timed program.
- When a malfunction (E1, E2, E3, E4, or P1) occurs, the Auto Start/Stop
timed program will also be cancelled.
8