Danby DPAC120090 Guide D'utilisateur page 6

Horizontal / Vertical Window Installation
For Horizontal Window Installation, refer to Fig. E and for Vertical Window Installation,
refer to Fig. F on previous page, while following the below instructions:
1) Select a suitable location, making sure you have access to an electrical outlet.
2) Install the intake / exhaust hoses (Accessories #1) to the rear of the unit.
3) Install the window slider kit (Accessories #5) as shown in Fig. E or Fig. F.
4) Attach the two intake / exhaust hose adapters (Accessories #3) to the end of each hose.
5) Attach the intake / exhaust adapters to the holes in the window kit, making sure the window
kit is securely in place.
NOTE: For vertical window installation, ensure that the exhaust hose adapter is above the
intake hose adapter (to prevent the unit from taking in hot exhaust air).
6) Plug power cord into a 115 V / 60 Hz grounded electrical outlet.
PATIO KIT
INSTALLATION
The patio kit has been designed to fit most standard patio doors. Please note that when the
patio kit is installed, the patio door will require a locking bar or other security
mechanisms; the patio door cannot be locked when the patio kit is installed.
Patio door: Minimum & Maximum
Patio
door
Patio Door Installation
Refer to Fig. G and Fig H while following the below instructions:
1) Select a suitable location, making sure you have access to an electrical outlet.
2) Install the intake / exhaust hoses (Accessories #1) to the rear of the unit.
3) Install the window slider kit (Accessories #5) as shown in Fig. G.
4) Attach the two intake / exhaust hose adapters (Accessories #3) to the end of each hose.
5) Attach the intake / exhaust adapters to the holes in the patio door kit, making sure the patio
door kit is securely in place.
NOTE: Ensure that the exhaust hose adapter is above the intake hose adapter (to prevent the
unit from taking in hot exhaust air).
6) Plug power cord into a 115 V / 60 Hz grounded electrical outlet.
INSTALLATION INSTRUCTIONS
Fig. H
Patio Slider Kit:
Minimum: 67.5cm (2.22ft)
Maximum: 210cm (6.88ft)
Fig. G
NOTE: The patio slider is a slider
accompanying the window kit, that has a
series of factory cut holes along its sides: use
these holes to screw the patio slider kit
securely into position, as depicted in Fig. H.
5