Albrecht AE 6491 ANC Manuel page 36

6. Operation / Buttons
6.1. AM/FM switch
You can select AM or FM modulation by pressing the AM/FM
button.
Please note that in the German 80 CH system it is possible (and
allowed) to listen in AM on all 80 channels, but transmission
is only possible on CH 1-40 in AM. During receive mode, the
bar graph shows the strengths of the received signal, during
transmission, it shows the relative output power. In dE and EU
settings, the AM power depends on the jumper setting on the
lower printed circuits board side (see country switching).
6.2. SCAN
Your AE 6491 ANC incorporates a scanning feature. The radio
will scan through all channels and will stop at BUSY channels. It
will stay on that channel further seven seconds after conversation
has stopped and then it will resume scanning.
• To start scanning, turn on the power first and adjust the
volume and squelch.
• Press the SCAN button to start scanning. The word SC will
appear in the LCD display and the unit will start scanning.
• If you want to stop scanning you can push the scan button
again or press the push to talk switch.
36