California CLLFS6FW-11 blanc Notice D'utilisation page 95

PROBLEM
Laundry remains
wet at the end of
the programme.
Alarm code Code interpretation
Abnormal water in
E1
and out
E2
The door is not closed
E3
Washing motor failure
E4
Abnormal drainage
E5
Abnormal water level
Water heater failure
E6
Water heating
E7 temperature sensor
failure
Ex (x is a
number
other than
the above)
POSSIBLE CAUSE
- Excessive foam might
have occurred and
automatic foam
absorption system
might have been
activated due to too
much detergent usage.
- Machine does not
switch to spinning step
when the laundry is not
evenly distributed in
the drum to prevent
any damage to the
machine and to its
surrounding environ-
ment.
1: Check whether the faucet is open;
2: Check whether the water pressure is too low or the water is
cut off;
3: Check whether the water inlet pipe is twisted;
After checking, if any error occurs, please contact maintenance.
1: Check whether the door is closed properly;
2: Check whether the clothes are pressed by the door;
After checking, if any error occurs, please contact maintenance.
Please restart after power off, if it still occurs, please contact
maintenance.
1: Clean the drain pipe filter;
2: Check whether the drain pipe is blocked;
After checking, if any error occurs, please contact maintenance.
After pressing the start button, it will automatically drain to the
washing water level and continue to run;
If any occurs, please contact maintenance.
Please restart after power off, if it still occurs, please contact
maintenance.
Please restart after power off, if it still occurs, please contact
maintenance.
Please restart after power off, if it still occurs, please contact
Other
maintenance.
SOLUTION
- Use recommended
amount of detergent.
- Laundry should be
rearranged and re-spun.
Troubleshooting and Solutions