Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Machine stopped
shortly after the
programme
started.
Foam is overflow-
ing from the
detergent drawer.
POSSIBLE CAUSE
- Machine might have
stopped temporarily due
to low voltage.
- Timer may stop during
water intake.
- Timer may stop during
heating step.
- Timer may stop during
spinning step.
- Machine does not
switch to spinning step
when the laundry is not
evenly distributed in the
drum to prevent any
damage to the machine
and to its surrounding
environment.
- Too much detergent is
used.
- Put detergent into the
machine suitable for the
programmes and
maximum loads indicat-
ed in the "Programme
and consumption table".
SOLUTION
- It will resume running
when the voltage restores
to the normal level.Pro-
gramme time does not
countdown. (On models
with display)
- Timer indicator will not
countdown until the
machine takes in
adequate amount of water.
The machine will wait until
there is sufficient amount
of water to avoid poor
washing results due to
lack of water. Timer
indicator will resume
countdown after this.
- Timer indicator will not
countdown until the
machine reaches the
selected temperature.
- Automatic unbalanced
load detection system
might be activated due to
the unbalanced distribution
of the laundry in the drum.
- Laundry should be
rearranged and re-spun.
- Mix 1 tablespoonful
softener and ½ l water and
pour into the main wash
compartment of the
detergent drawer.
- When you use additional
chemicals (stain removers,
bleachs and etc),reduce
the amount of detergent.
Publicité
