Bresser VentAir Mode D'emploi page 23

3. Please do not use other electrical products, such as headphones or
speakers, operating on the same signal frequency (433 MHz).
4. Electrical devices operating on the same signal frequency may also cause
interference. This can include devices used in the neighborhood as well.
Using multiple sensors with the main unit
1. The main unit can be connected with a maximum of up to 3 transmitters.
2. Press the touch control CH/ (12c) to switch between the displays of each
channel. The main unit will display the information of the corresponding
transmitter. When the symbol
the automatic display rotation is activated. The display changes between
the information of the connected remote sensors every 10 seconds.
NOTE!
The function to change the channels by pressing the CH/
can be used only if more than one outdoor sensor is connected with
the main unit. Otherwise this function is disabled.
Zudem müssen auch für alle angeschlossenen Sensoren
entsprechend unterschiedliche Kanäle eingestellt werden. Lesen Sie
hieru auch das folgende Kapitel "Sensor-Funktionen".
In addition, different channels must be set for all connected sensors.
Also read the chapter "Sensor functions".
Background illumination
Press LIGHT button (5) to to turn on the background. It will be turned off
automatically after approx. 5 seconds.
Sensor functions
Channel selection
1. Remove the battery compartment cover (27) from the sensor.
2. Move the CH switch (24) to the position (1-3) that corresponds with
the channel which will be used for transmission (select channel 1 if
only one outdoor sensor is connected). If you would like to connect
more than one outdoor sensor with the main unit, different channels
need to be selected for each sensor.
3. Once the weather station receives radio signals from the sensors,
the alternating temperature values of the different channels will be
updated on the weather station every 1-2 minutes.
4. Replace the battery compartment cover.
Manual_7007402_Thermo-Hygrometer-VentAir_en-de-fr-es-it-nl_BRESSER_v052024a.indb 23 Manual_7007402_Thermo-Hygrometer-VentAir_en-de-fr-es-it-nl_BRESSER_v052024a.indb 23
is displayed near the channel information
GB
button
23
31.05.2024 13:19:53 31.05.2024 13:19:53