Bresser VentAir Mode D'emploi page 20

for 20 seconds, the existing setting will be saved and the device
returns to normal display mode.
NOTE!
When choosing ON for 24 hour measurement data storage all stored
MIN/MAX values for temperature and humidity will be deleted daily at
0:00h! When choosing OFF the data will be stored indefinitely until a
battery change is required.
Temperature and humidity
1. Once the batteries are installed the main unit will start displaying
the interior measurement information. The main unit will display the
information from the outdoor sensor for the first time approximately
3-4 minutes after the power supply was established.
2. Press CF/SET touch control (12b) to switch screen display between °C
or °F. Screen display will change for outdoor temperature as well as
for indoor temperature.
Indoor humidity indicator
The indoor humidity indicator (6) displays the following conditions:
DRY WET
COMFORT
COMFORT DRY
NOTE!
Read chapter "Ventilation indicator" for more information.
Temperature and humidity MAX/MIN records
1. Press the touch control MEM/
the values for current, minimum (MIN) and maximum (MAX)
temperature and humidity. The display will change for the indoor
temperature as well as for the outdoor temperature.
2. The MIN/MAX temperature and humidity values will be recorded
automatically.
NOTE!
Depending on the selected type for measurement data storage the
MIN/MAX values will be saved for 24 hours or until batteries need to
be changed (Read chapter "Manual time setting and other settings").
20
Manual_7007402_Thermo-Hygrometer-VentAir_en-de-fr-es-it-nl_BRESSER_v052024a.indb 20 Manual_7007402_Thermo-Hygrometer-VentAir_en-de-fr-es-it-nl_BRESSER_v052024a.indb 20
WET Indoor humidity between 66% and 95%
COMFORT Indoor humidity between 45% and 65% DRY
DRY WET Indoor humidity between 20% and 44%
WET
(12a) several times to switch between
31.05.2024 13:19:53 31.05.2024 13:19:53