MAC Audio MPExclusive 2.0 XL Mode D'emploi page 11

FIG. 2 STEREO MODE
Connect and set the amplifier as shown in Fig. 2 if it is to be controlled with two output channels and to use two
loudspeakers. The high-pass filter must also be activated if the amplifier is also used for satellite loudspeakers.
See Chapter 5.3.
(1) To the car radio, left output
(2) To the car radio, right output
(3) Loudspeaker left
(4) Loudspeaker right
FIG. 3 BRIDGE MODE WITH STEREO CAR RADIO
If the amplifier has to generate more power to operate a subwoofer, connect and set it as shown in Fig. 3. The use
of the low-pass filter is described in Chapter 5.2.
(1) To the car radio, left output
(2) To the car radio, right output
(3) Subwoofer
FIG. 4 MONO MODE WITH ONE CAR RADIO WITH SUBWOOFER OUTPUT
(1) To the car radio, subwoofer output
(2) Subwoofer
FIG. 5 OPERATING ELEMENTS AND IN/OUTPUTS
(1) Outputs for connecting additional amplifiers
(2) Low-level input
(3) Input level control
(4) Bass-booster control
(5) Cross-over frequency control for the high pass
(6) Cross-over frequency control for the low pass
(7) (FULL) / LPF (low pass filter) / HPF (high pass filter) option switch
(8) Mono-stereo switch
11
https://manual-hub.com/