Pioneer MEH-P7100R Manuel D'installation page 9

Installing the Unit on a Left-Hand-
Drive Car
Note:
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Secure inner holder to the inner cir-
cumference of the steering wheel
with belt. (Fig. 7)
• Fit the inner holder to the steering wheel so
that the arrow-marked side faces the driver as
shown below.
Belt
2. Cut the extra portion of the belt at
the center of the inner holder. (Fig.
8)
• Keep the cut-off portion of the belt as a
spare.
3. Install outer holder on the inner
Inner holder
4. Install the remote control unit in
Fig. 7
Fig. 8
holder and secure with screws. (Fig.
9)
• Tighten the screws with the supplied hexago-
nal wrench.
Screw
Outer holder
the holder. (Fig. 10)
• When removing the remote control unit from
the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.
Release Section
Fig. 9
Fig. 10
8