Publicité
Les langues disponibles
Les langues disponibles
19
15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 11 13 14
87.5
Fig. 16. SINEAX DME in housing T24 screw hole mounting
brackets pulled out.
11. Safety notes
Before you start the device check for which power supply
it is built.
Verify that the connection leads are in good condition and
that they are electrically dead while wiring the device.
When it must be assumed that safe operation is no longer
possible, take the device out of service (eventually
disconnect the power supply and the input voltage!).
This can be assumed on principle when the device shows
obvious signs of damage.
The device must only be used again after troubleshooting,
repair and a final test of calibration and dielectric strength
in our factory or by one of our service facilities.
When opening the cover, live parts may be exposed.
Calibration, maintenance or repair with the device
open and live must only be performed by a qualified
person who understands the danger involved.
Capacitors in the device may still be charged even
though the device has been disconnected from all
voltage sources.
After repair on maintenance and closing of the device, the
insulation must be tested with high voltage with the
values listed in the technical data.
6.5
12
123.4
Meaning of the symbols on the device
The symbols on the device have the following meaning:
Warning of danger
(Caution, see documentation!)
Class II device
12. Instrument admission
CSA approved for USA and Canada
file-nr. 204767
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to both part
15 of the FCC Rules and the radio interference regulations
of the Canadian Department of Communications: These
limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is like to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
35
Publicité
