Salicru SLC TWIN RT Serie Mode D'emploi page 59

Plugged in power cord
Starting
Fig. 28. UPS start-up sequence.
6.1.2.2. UPS start-up without mains voltage
(with battery).
Before using this feature, the UPS must have been powered
by the mains with the output enabled at least once.
Start-up via battery (Cold Start) can be deactivated. See the user
settings.
Press and hold the on/off button for 1 second, the buzzer will
1.
beep once.
Press the on/off button again (1 second) when the UPS system
2.
is running.
The UPS is running in Battery mode; the audible alarm activates
3.
every second.
UPS in battery mode
Fig. 29. Start-up sequence from the battery.
USER MANUAL
6.1.3. UPS shutdown.
1.
2.
3.
UPS in normal mode
Fig. 30. Shutdown sequence.
Starting
Press and hold the on/off button for 3 seconds, the buzzer will
beep once.
The UPS goes into Bypass or Standby mode depending on how
it is configured.
The UPS enters Standby mode right after unplugging the
power cord, followed by shutdown.
Unplug the power cord,
UPS shutting off
SLC TWIN RT3 0.7÷3 kVA UNINTERRUPTIBLE POWER SUPPLY (UPS)
UPS in standby mode
59