mundoclima MUSTR-H8 Manuel D'installation Et L'utilisauter page 66

REMOTE CONTROLLER
Indicators on LCD
Information are displayed when
the remote controller is powered
up.
How to use the buttons
3 ON/OFF
SHORT
CUT
TIMER
1
MODE
ON
TEMP
TIMER
FAN
OFF
SLEEP
TURBO LED
Mode display
AUTO COOL
HEAT FAN
Displayed when data transmitted.
Displayed when remote controller is ON.
Battery display(low battery detection)
Not available for this unit
Displayed when TIMER ON time is set.
Displayed when TIMER OFF time is set.
Show set temperature or room
temperature, or time under TIMER
setting.
Displayed in Sleep Mode operation.
Not available for this unit
Not available for this unit
Not available for this unit
Fan speed indication
Low speed
Medium speed
High speed
Auto fan speed
Note:
All indicators shown in the figure are for the purpose
of clear presentation. But during the actual operation
only the relative functional signs are shown on the
display window.
Auto operation
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the
desired temperature. The temperature can
be set within a range of 17 C~ 30 C in 1 C
increments.
3. Press the ON/OFFbutton to start the air
2
conditioner.
NOTE
1. In the Auto mode, the air conditioner can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setting
temperature on the remote controller.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3. If the Auto mode is not comfortable for you , the
desired mode can be selected manually.
66
DRY
O O O