Sony SU-WL500 Installation page 2

Thank you for purchasing this product.
To Customers
Sufficient expertise is required for installing this
product. Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay
special attention to safety during the installation.
Sony is not liable for any damages or injury
caused by mishandling or improper installation, or
installing any other than the specified product.
Your Statutory Rights (if any) are not affected.
WARNING
If the safety precautions are not observed or the
product is used incorrectly, it may result in serious
injury or fire.
This manual shows the correct handling of the
product and important precautions necessary to
prevent accidents. Be sure to read this manual
thoroughly and use the product correctly. Keep this
manual available for future reference.
To Sony dealers
Sufficient expertise is required for installing this
product. Be sure to read this manual thoroughly to do
the installation work safely. Sony is not liable for any
damages or injury caused by mishandling or
improper installation. Please give this manual to the
customer after installation.
To install the TV to the wall in portrait orientation, the SU-WL500 Wall-Mount Bracket, spacers, and screws listed
below are necessary.
For further details/terms & conditions, contact the sales representative for professional use.
TV model
XBR-65X850D
XBR-55X850D
KD-65X8500D
KD-55X8500D
2
(GB)
Wall-Mount Bracket
Model Qty
SU-WL500 1
On Safety
Products by Sony are designed with safety in mind. If
the products are used incorrectly, however, it may
result in a serious injury through fire, electric shock,
the product toppling over, or the product dropping.
Be sure to observe the precautions for safety to
prevent such accidents.
CAUTION
Specified products
The following products are subject to change
without notice, may be out of stock, or
discontinued.
Some models may not be available in certain
regions.
LCD Color TV
Spacer
Specification Qty
Washer with an
outside diameter of 18
mm, inside diameter
of 10 mm, and 20
thickness of 2 mm
(SONY Part Number
7-688-000-32)
XBR-65X850D
XBR-55X850D
KD-65X8500D
KD-55X8500D
Screw
Specification Qty
PSW M6×25 mm
(SONY Part Number 4
4-577-327-01)