Publicité
Les langues disponibles
Les langues disponibles
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Care for parts.
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver, wrench and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. MOUNTING THE LEGS TO MAIN BARREL
Parts Required:
1
x
Main Barrel (#11)
2
x
Stationary Leg (#14)
2
x
Leg with Wheel Axle (#15)
16 x
Screw (#A)
16 x
Washer (#D)
16 x
Locking Washer (#E)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit.
Lay the main barrel on its side, hopper end pointed downward, on the
cardboard. Note illustration.
•
Mount one stationary leg to the hopper end of the main barrel using
four screws, locking washers, and washers, through the four pre-drilled
holes. Repeat installation for second stationary leg. Mount one leg
with wheel axle to the floor end of the main barrel using four screws,
locking washers, and washers, through the four pre-drilled holes.
Ensure the leg with pre-installed bottle opener faces forward.
Repeat installation for second leg with wheel axle.
2. INSTALLING THE BOTTOM SHELF
Parts Required:
1
x
Bottom Shelf (#21)
4
x
Screw (#A)
4
x
Locking Washer (#E)
4
x
Washer (#D)
Installation:
•
From underneath, secure the bottom shelf to all each leg using a screw,
locking washer, and washer. Ensure the flat surface of the shelf is facing up.
ASSEMBLY PREPARATION
USA: (480) 923-9630 | Canada (Toll Free): 1-877-942-2246
www.pitboss-grills.com
ASSEMBLY INSTRUCTIONS
1
15-1
11
14-1
D E A
2
21
A D
15-2
14-2
E
7
Publicité
