Trix BR 290 Mode D'emploi page 9

Safety Notes
• This locomotive is only to be used with the operating
system it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This locomotive must never be supplied with power from
more than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
Important Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• This specially prepared model is an exclusive version,
which reproduces the condition of the original after many
years of operation in wind and weather.
The artificial weathering was separately applied with
careful hand work by experienced artisans. Despite
a final fixing of the colors with varnish, this additional
application of color does not form a homogeneous, hard
coating.
Therefore, please handle the model with special care
and avoid, scratching, rubbing, or wiping the surface and
the details. Please do not use liquid cleaners or cleaning
solutions.
Please note that the spare parts for this model weathered
at the factory are only available in non-weathered
version.
• Please see your authorized Trix dealer for repairs or
spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The full range of functions is only available under DCC
and mfx.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• Automatic variable position of the locomotive engineer.
When the locomotive exceeds a permanently set
minimum speed, the locomotive engineer moves into the
correct cab.
The movement of the locomotive engineer may not be
blocked.
• Minimum radius for operation is 360 mm/14-3/16".
Multi-Protocol Operation
Analog Operation
This decoder can also be operated on analog layouts or ar-
eas of track that are analog. The decoder recognizes alter-
9