VINCENT SA-T8 Manuel D'utilisation page 31

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "REC OUTPUT" (7) on the back of the appliance to connect an
analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance that is
intended for receiving the unchanged, fixed stereo output level (line level) from the signal source selected
on the amplifier at any given time. The output level is independent from the volume. The input signals at the
XLR connectors can not be obtained at the recording output (7) and thus can not be used as a source for
recordings. Please note that while the preamplifier is muted (5)(11) the recording output is switched off.
SA-T8
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slight-
ly alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the
"REC" terminal only for as long as the recording is actually being made.
STANDBY CONTROL (POWER CONTROL)
Many AV-Systems consist of a multitude of individual components. To avoid the necessity of switching them
on and off before and after every use, many manufacturers have equipped their devices with what is
known as "POWER CONTROL" circuit or "TRIGGER". This kind of remote-controlled standby circuit is
used primarily for preamplifier and power amplifiers. Particularly for preamplifiers and main amplifiers
this kind of remote standby control is utilized, as power amplifiers are often placed far from other devi-
ces near the speakers. To employ these functions, direct or indirect cable connections must be made bet-
ween the preamplifier (or integrated amplifier) and all the devices which support this function. The
"POWER CONTROL" function operates in such a way that each switching on or off of one device in the
system (usually the preamplifier) automatically brings about the switching on or off of all the connected
devices which support this function. Please keep in mind that all devices which respond to the power con-
trol are not disconnected from the mains network when switched off. They are set to a standby state inste-
ad. For connecting cables, two-core cables with 3.5 mm jack plugs (mono) are used. For each connecti-
on between two devices one of those cables is needed.
If you don't wish to use this function or if the other components do not support it, all you have to do is
leave out these cable connections.
RCA connection
CONNECTIONS FOR THE
Recording device,
e.g. tape recorder
LINE IN
Vincent
31